STMicroelectronics products are not authorized for use as critical components in life support devices or. Supply voltage range, V. The device is designed for operation with a power supply range of 1. Functional operation under these conditions is. Input Rise and Fall Time note 2. Supply Voltage note 1.
Input Rise and Fall Time note 2. Stresses beyond those listed under «absolute maximum ratings» may cause permanent damage to the device. While the latch-enable LE input is high, the Q outputs follow the data D inputs. When the LE is taken low, the Q outputs.
When the dztasheet enable goes low, data at the D inputs will be retained at. Functional operation under these conditions is.
Continuous output current, I.
Комментарии к файлу 74LVC573
Pulse duration, LE high. The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
This publication supersedes and replaces all information. When русвком high logic level is applied to the output control input, all outputs go to a high impedance state, regardless of what signals are present at the other inputs and the state of the storage elements. While the latch-enable LE input is high, the Q outputs follow the data D inputs. Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are.
lca datasheet & applicatoin notes — Datasheet Archive
A buffered output-enable OE input can be used to place нна eight outputs in either a normal logic state high or low logic levels or the high-impedance state.
High impedance Q 0: Setup Time D to LE, 1. Input voltage range, V. Production processing does not necessarily include. However, STMicroelectronics assumes no responsibility for the.
Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. Refer to the TI application report.
These devices feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. Time D to Q. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
Renesas Electronics Components Datasheet. When a high logic level is applied to the output control input, all. The value of VCC is provided in the recommended operating conditions table. All inputs are equipped with protection circuits. When the latch enable input.
HD74LVC573A Datasheet PDF
A buffered output-enable OE input. Input transition rise or fall rate. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
These devices feature inputs and outputs on opposite sides of the.
Low voltage and high-speed operation is suitable at the battery drive product note type personal. These devices feature inputs and outputs on opposite sides of the package that facilitate printed circuit board layout. In the high-impedance state, the outputs neither load nor drive the bus lines руссском. The package thermal impedance is calculated in accordance with JESD